Phone Settings

This section walks you through getting a new phone ready for automation in TEO, from first connection to the per‑device settings.

How to use this section

Follow these steps in order. Phone Preparation describes each of them in detail.

1. Check the phone against Supported devices: other models and OS versions are not registered.
2. Enable developer access on the phone before you connect it: do the Before Prepare items of the checklist at the top of the brand page (Samsung · Xiaomi · Pixel). For an iPhone, connect it to the Mac and trust the computer first, then turn on Developer Mode (iOS).
3. Connect the phone to the Test Node and accept the Allow USB debugging or Trust This Computer? prompt. Automatic Device Discovery adds it on the Mobile ID's page as NewDevice_<number>.
4. Complete the Mobile ID: a descriptive name and the real MSISDN, National Format, IMSI and IMEI. IMSI and IMEI start with random placeholder values, and tests fail until they are replaced.
5. Android: run Prepare from the Mobile ID's page. It applies most of the remaining settings and emails you the result of each step.
6. Finish by hand: on Android, the After Prepare items of the brand checklist and any step the email lists as failed; on an iPhone, all settings on the iOS page (Prepare is not available for iPhones).

For the lab, print the checklists for all brands (PDF).

MCM modems are set up differently: see MCM modem setup. If something does not work, see Setup troubleshooting.

Supported devices

The supported phones and OS versions are listed on Supported devices.